Instruction

Insert Illumin8 Menorah into the Car Base

Ensure it’s fully pressed in by applying some pressure

Follow “tabletop mount instructions” to insert pieces for front/back stability, as they fit into the Car Base

Tighten orange screws

Loop rubber bands around hooks for extra security (see video)

Ensure the car roof is clean

Align the Menorah over your car’s roof at your desired placement location

Gently place the magnets down

Plug the Illumin8 Menorah into your car’s power system

Illumin8 it!

Tips & Warnings for Car Roof Installation

Speed: max speed 70 MPH; reduce speed in windy conditions or remove from car when using menorah with sign do not exceed 55mph. Make sure magnets are flush with the car roof, and not on any bumps or grooves If driving at high speeds for long periods, use tie wraps to secure the two snapped pieces of the Menorah base together

Speed

Max speed 70 MPH; reduce speed in windy conditions or remove from car. when using menorah with sign do not exceed 55mph.

Make sure whole magnet is flat on car

Make sure magnets are flush with the car roof, and not on any bumps or grooves

Ziptie supporting legs for fast speeds

If driving at high speeds, use tie wraps to secure the two snapped pieces of the Menorah base together. (Not to tight) or don't use them.

To Remove from car

Gently remove the magnets corner by corner

Ensure window is clean in the area where suction cups will be placed

Insert the two included suction cups into the semi-loops on both sides of the Menorah 

Push the suction cups against the window at the desired placement location

With your finger, rub the suction cup to clear out as much air as possible; by doing this, you ensure a very durable seal

Illumin8 it!

If the two facets of the sign are already screwed together, undo the screws and pull the facets apart 

Place one facet of the sign where it fits in correctly, towards the top of the Menorah (the first and last letter of the sign should be in line with the edges of the outer Menorah branches).

Place the other facet directly behind it, so that they sandwich the Menorah’s branches

Push the facets together so that they ‘click’

Use the two screws to fully fasten the sign facets together

Illumin8 it

Tips & Warnings for Car Mount Installation

When using the sign on the Illumin8 Menorah car mount use the pla vertical and under 50mph

This kit ensures the Illumin8 Menorah can be placed on a table and not fall forwards or backwards

Take one of the two pieces included in this kit and push it against the bottom of the Menorah at the center (directly underneath the Shamash), perpendicular to the Menorah

Place the second piece and do the same with it, but from the back of the Menorah

The two pieces should meet underneath the Menorah, at its centrepoint

Push the two pieces until they click, holding the Menorah in place

Illumin8 it!